
RCA Crusher Run in Maryville, TN
Recycled crusher run gravel for driveways, pads, and base. Serving Knoxville, Maryville, and East Tennessee.
The quick answer
Crusher run is crushed stone with the fines left in, so it packs down hard and stays put. We sell the recycled version: RCA crusher run, made from clean concrete crushed at our yard at 245 Brookdale Rd in Maryville. It is 1 inch minus, weighs about 1.4 tons per cubic yard, and is the go-to base for driveways, shed pads, and slabs.
Pick it up at the yard or have it delivered anywhere around Knoxville, Maryville, Alcoa, and the rest of East Tennessee.
RCA crusher run specs
| Material | Recycled concrete aggregate (RCA), crushed on site in Maryville |
|---|---|
| Size range | 1 inch minus: pieces up to about 1 inch down to dust |
| Fines | Yes. The fines are what let it lock together |
| Approx. weight | About 1.4 tons per cubic yard (compacted, in place) |
| Compaction | Excellent. Packs into a hard, stable surface with a plate compactor or roller |
| Drainage | Moderate. Low fines for a crusher run, but still not a drainage stone |
| Lab tested | Gradation meets TDOT Section 903 Type A base, Gradings A, B and C (UES, Nov 2026) |
Weights are approximate. Moisture and how tightly the material is compacted change the number a little from load to load.
Lab tested by an independent lab
We sent a sample of our crusher run to UES, an independent testing lab in Knoxville, in November 2026. The gradation met TDOT Section 903 Type A base for Gradings A, B and C. It is non-plastic, so there is no clay to turn it to mud, and the fines are low, so it drains better than most crusher run.
| Passing 1 inch | 96% |
|---|---|
| Passing 3/8 inch | 65% |
| Passing #4 | 46% |
| Passing #200 (fines) | 5% |
| Max dry density (Proctor) | 110.9 lb per cubic foot |
| Best moisture to compact | 15.5% |
| Plasticity | Non-plastic (no clay) |
For contractors
Wet it well before you roll it. Recycled concrete soaks up more water than quarry stone, and it hits its best density near 15 percent moisture. Need the full report for a submittal? Call (865) 999-0857 and we will email it. Results are from one sample. We are not on the TDOT approved source list yet.
Best uses for crusher run
- ✓Driveway base and gravel driveways (crown it so water runs off)
- ✓Shed pads, carport pads, and hot tub pads
- ✓Equipment and parking pads for trucks and trailers
- ✓Sub-base under concrete slabs, patios, and pavers
- ✓Base course under an RCA #57 or asphalt top layer
- ✓Building up low spots, farm lanes, and construction entrances
| Job | Crusher run depth | Tip |
|---|---|---|
| Gravel driveway (cars, pickups) | 4 to 6 in. compacted | Crown it so water sheds. Optional 2 in. of #57 on top |
| Driveway for heavy trucks or soft ground | 6 to 8 in. compacted | Two lifts. Add geotextile fabric over soft clay |
| Shed, carport, or hot tub pad | 4 in. compacted | Extend 1 ft past the building on each side |
| Under a concrete slab or sidewalk | 4 in. compacted | Even, firm bed for the pour |
| Paver patio base | 4 to 6 in. compacted | Then 1 in. of bedding sand or screenings |
| Construction entrance or farm lane | 6 in. or more | Top up ruts as they form |
Lay it in lifts of about 3 to 4 inches and compact each lift. Wet each lift well; it packs best near 15 percent moisture. For a driveway, 4 to 6 inches of compacted crusher run over firm subgrade handles everyday cars and pickups. For heavy trucks or soft ground, go deeper. Read our RCA driveway guide for the full install.
How much crusher run do you need?
Here is the coverage per 100 square feet (a 10 by 10 foot area) at common depths, using 1.4 tons per cubic yard.
| Depth | Cubic yards per 100 sq ft | Tons per 100 sq ft |
|---|---|---|
| 2 inches | 0.62 | 0.86 tons |
| 4 inches | 1.23 | 1.73 tons |
| 6 inches | 1.85 | 2.59 tons |
The math
Cubic yards = square feet x (depth in inches / 12) / 27
Tons = cubic yards x 1.4
Example at 4 inches: 100 x (4 / 12) / 27 = 1.23 cubic yards. 1.23 x 1.4 = 1.73 tons. A 12 by 50 foot driveway is 600 square feet, so 6 x 1.73 = about 10.4 tons.
Want it done for you? Plug your length, width, and depth into the gravel calculator. Add 5 to 10 percent for compaction and uneven subgrade.
RCA crusher run vs virgin crusher run
We make the recycled version on site and also carry virgin crusher run. Here is how they compare in general terms, so you can decide which fits your job.
| Factor | RCA crusher run | Virgin crusher run |
|---|---|---|
| Source | Crushed from clean concrete tear-outs | Blasted and crushed from a quarry |
| Compaction | Compacts hard, locks in place | Compacts hard, locks in place |
| Weight per yard | A little lighter, so a ton covers a bit more area | Slightly heavier per cubic yard |
| Look | Gray to tan, some color variation, the odd brick piece | Uniform gray or blue-gray |
| Environmental | Keeps concrete out of the landfill, counts as recycled content | New material mined from the ground |
| Where to buy here | Our Maryville yard | We also carry virgin crusher run. Call for availability |
Bottom line: for a base that gets compacted and covered or driven on, RCA does the same work. Our gradation tested within TDOT Type A base Gradings A, B and C. If your job has a spec or you want a uniform decorative look, check with your engineer or call us for the lab report.
How to order
Pick up at the yard
Bring your pickup, trailer, or dump truck to 245 Brookdale Rd, Maryville, TN 37801. We load you with the loader. No appointment needed.
Hours: Mon-Fri 7 AM to 5 PM, Saturday 8 AM to noon, closed Sunday.
Get it delivered
Tell us the tons and the drop address and we line up the truck. Material and hauling on one invoice.
How our trucking service works →Crusher run FAQ
What is crusher run?
Crusher run is crushed stone that keeps everything from the largest size down to fine dust. The fines fill the gaps between the larger pieces, so it packs down into a hard, stable base. Ours is RCA crusher run, made by crushing clean concrete at our Maryville yard.
Is recycled crusher run as good as virgin crusher run?
For driveways, pads, and base under slabs it performs the same job. It compacts tight, carries trucks and equipment, and holds its shape. It can show a little more color variation and the odd bit of brick, which does not affect performance as a base.
How much crusher run do I need for a driveway?
Plan on about 1.73 tons per 100 square feet at 4 inches deep. A 12 by 50 foot driveway (600 square feet) at 4 inches needs roughly 10.4 tons. Use our calculator for your exact dimensions.
How much does crusher run cost near Maryville and Knoxville?
Call (865) 999-0857 for current pricing. The rate depends on how many tons you need and whether you pick up at the yard or want it delivered.
Can I pick up crusher run in my own truck or trailer?
Yes. Come to 245 Brookdale Rd in Maryville, Mon-Fri 7 AM to 5 PM or Saturday 8 AM to noon, and we load you. Know your truck or trailer weight limit before you come.
Does your crusher run meet TDOT specs?
In November 2026 an independent lab (UES) ran a gradation test on our crusher run. It met TDOT Section 903 Type A base gradation for Gradings A, B and C. Gradation is one of several tests TDOT uses, and we are not on the TDOT approved source list yet. If your job has a spec, call us and we will email you the lab report.
How do I compact recycled crusher run?
Wet it well. In the lab, our crusher run reached its best density (110.9 lb per cubic foot) at about 15.5 percent moisture, which is wetter than quarry stone needs because the old concrete soaks up water. Spread it in 3 to 4 inch lifts, wet each lift, and roll or plate compact. Rolled dry, it will not get as tight.
Is crusher run the same as crush and run, DGA, or road base?
Mostly, yes. Crusher run, crush and run, crusher run gravel, dense grade aggregate (DGA), 21A, and road base all describe the same idea: crushed stone with the fines left in so it compacts. The exact gradation varies by quarry and state spec. Ours is recycled (RCA) crusher run, 1 inch minus, and its gradation meets TDOT Section 903 Type A base.
Is paver base the same as crusher run?
Paver base is usually a crusher run type material, and compacted crusher run works well as the base under pavers and patios. Lay 4 to 6 inches of compacted crusher run, then about 1 inch of bedding sand or fine screenings for the pavers to sit in.
Crusher run or #57 stone: which one do I need?
Use crusher run where you need a hard, packed surface: driveway base, shed pads, slab and paver base. Use #57 where water needs to pass through: French drains, behind retaining walls, and pipe bedding. Many driveways use both, crusher run as the base and #57 on top.
Can I put crusher run under a concrete slab?
Yes. 4 inches of compacted crusher run is a common sub-base under slabs, patios, and sidewalks. It gives the concrete an even, firm bed. Compact it well and keep it damp, not soaked, right before the pour.
How many tons of crusher run fit in a dump truck?
A single-axle dump truck usually hauls about 6 to 8 tons, a tandem about 12 to 15 tons, and a tri-axle about 18 to 20 tons. Legal weight limits, not bed size, decide the load. At 1.4 tons per cubic yard, a 15 ton tandem load is roughly 10.7 cubic yards.
Does crusher run drain well?
Not as well as clean stone. The fines that make it compact also slow water down. If drainage is the main goal, use RCA #57 stone, or put #57 under or around the crusher run where water collects.
Other products and tools
Need crusher run this week?
Call with your tonnage and whether you are picking up or need delivery. We will give you current pricing on the phone.