
How Thick Should Crusher Run Be for a Driveway?
Building in Blount or Knox County? We sell lab-tested RCA crusher run (meets TDOT 903 Type A gradation) and virgin crusher run for shed pads, driveways, and paver base. Pickup at our Maryville yard or delivery. Call (865) 999-0857 for pricing.
See RCA crusher run →Quick answer: A crusher run driveway should be 4 inches thick after compaction for cars on firm soil, 6 inches for pickups and regular truck traffic, and 8 to 12 inches for RVs, heavy delivery trucks, or dump trucks. Add about 2 inches over clay or soft ground and lay geotextile fabric first. Place it in 3 to 4 inch loose lifts, compact each one, and crown the surface so water runs off. A 12 foot wide driveway takes about 21 tons per 100 feet at 4 inches. We make RCA crusher run at our Maryville yard.
This post answers one question: how deep the crusher run needs to be. If you are still choosing between materials, read crusher run vs #57 stone. For the full build from layout to edging, see the gravel driveway DIY guide. For cost and lifespan, see the RCA driveway guide.
How thick should crusher run be for each type of vehicle?
Depth follows weight. The heavier the axle load, the more stone you need to spread that load out before it reaches the dirt. These numbers are compacted depth over firm, well drained soil.
| Use | Compacted depth | Loose depth to spread |
|---|---|---|
| Foot traffic, walkways, mower paths | 2 to 3 in | 3 to 4 in |
| Cars and small SUVs | 4 in | 5 in |
| Pickups, vans, occasional trailer | 6 in | 7 to 8 in |
| RVs, propane or delivery trucks, box trucks | 8 in | 10 in |
| Loaded dump trucks, concrete trucks, equipment | 10 to 12 in | 12 to 15 in |
A few notes on reading the table:
- "Occasional" matters. One concrete truck during construction is different from a fuel truck every month. Size the driveway for the heaviest vehicle that will use it regularly, and expect to touch up after one-off heavy loads.
- Turnarounds and parking spots get more. Where tires turn and sit, the stone takes more abuse. Add an inch or two in those spots.
- Steep grades need the full depth. Wheel spin on a hill tears up a thin layer fast.
If your driveway will see loaded dump trucks or equipment on a regular basis, it is closer to a haul road than a driveway. At that point, get the subgrade checked and plan for 12 inches or more with fabric, and call us to talk through the build.
How does soil type change the depth?
The table assumes firm ground. East Tennessee rarely hands you that. Most lots around Maryville and Knoxville sit on red clay, and clay loses strength when it gets wet.
| Subgrade | What to do |
|---|---|
| Firm, well drained soil or old gravel | Use the table as is |
| Red clay that stays firm when dry | Add 2 in and use geotextile fabric |
| Clay that pumps or squishes underfoot | Dig out soft spots, fabric, add 2 to 4 in |
| Wet area, spring, or low spot | Fix the water first, consider RCA #57 under the crusher run |
| Fill dirt that was never compacted | Compact the fill first, then add 2 in |
Geotextile fabric is the cheapest insurance on clay. It is a woven sheet that sits between the dirt and the stone. Without it, wheel loads push stone down into wet clay and pull clay up into the stone, and in two seasons your 6 inches of base acts like 3. With it, the stone stays clean and keeps its full depth. Use a woven stabilization fabric, not thin landscape fabric.
Soft spots need to come out. If a boot sinks or the ground ripples when you walk it, dig that area out until you hit firm soil and backfill it with compacted crusher run in lifts. Driving over a soft spot does not fix it. It just hides it until spring.
Wet sites may need a drainage layer. A few inches of RCA #57 stone under the crusher run gives water a path out. Pair that with a ditch or a French drain along the uphill side so water does not keep flowing under the driveway.
Should crusher run go down in one layer or in lifts?
In lifts. This is where most thin feeling driveways come from: the depth was right on paper, but it was dumped and spread in one pass.
A plate compactor or small roller only pushes force so far down. If you spread 8 inches loose and compact the top, the top 3 or 4 inches gets tight and the bottom stays fluffy. Under load, the soft bottom shifts and the hard top cracks and ruts.
A simple plan for a homeowner with a rented plate compactor:
- Spread 3 to 4 inches loose.
- Mist it with a hose until it is damp but not muddy.
- Make 3 to 4 passes with the plate, overlapping each pass.
- Repeat until you reach finished depth.
A 6 inch compacted driveway is usually two lifts. An 8 inch driveway is two or three. Bigger rollers can handle thicker lifts. The aggregate compaction guide has lift depth by compactor size and the moisture details.
How much does crusher run shrink when compacted?
Crusher run loses roughly 15 to 25 percent of its loose thickness when it is wetted and compacted. That is why the table above lists a loose number. If you want 4 inches finished, spread about 5. If you want 6, spread 7 to 8 across two lifts.
This also affects your order. Tonnage is based on compacted volume, and the weight of stone does not change when you compact it. RCA crusher run runs about 1.4 tons per cubic yard compacted in place. Add roughly 10 percent to your order for waste, uneven subgrade, and edges.
How do you crown a crusher run driveway?
Depth means nothing if water sits on it. Standing water softens the subgrade underneath and every soft spot turns into a pothole.
- Crown or cross slope: About 2 percent, which is 1/4 inch of fall per foot. A 12 foot driveway with a center crown sits about 1.5 inches higher in the middle than at each edge.
- Shape the subgrade, not just the top. Cut the crown into the dirt before you add stone so every lift is the same thickness across.
- Give water somewhere to go. A shallow ditch or swale along the sides keeps runoff from soaking back under the edges.
- Contain the edges. A firm grass shoulder or timbers keep the crusher run from creeping out and thinning at the sides.
How many tons of crusher run for a 100 foot driveway?
Here is RCA crusher run at 1.4 tons per cubic yard, per 100 feet of driveway, before the 10 percent extra.
| Depth (compacted) | 10 ft wide | 12 ft wide |
|---|---|---|
| 4 in | 17.3 tons | 20.7 tons |
| 6 in | 25.9 tons | 31.1 tons |
| 8 in | 34.6 tons | 41.5 tons |
For a 250 foot driveway, multiply by 2.5. For a 50 foot driveway, cut in half. Plug your exact length, width, and depth into our gravel calculator, and see tons vs cubic yards if you are comparing quotes that use different units.
The formula if you want to check it yourself: length x width x depth in feet, divided by 27 for cubic yards, times 1.4 for tons.
What about topping up an old driveway?
If the old gravel driveway has a firm base and just looks thin, you do not need to start over.
- Grade out ruts and potholes so the surface is smooth and crowned.
- Compact the old surface.
- Add 2 to 3 inches of crusher run and compact it.
If the old driveway pumps mud through the surface or has spots that sink every spring, the base failed. Topping it up will not hold. Dig out those areas, add fabric, and rebuild them to full depth.
Common depth mistakes
- Measuring loose depth and calling it done. Four inches loose finishes near 3.
- Same depth everywhere. Turnarounds, the apron at the road, and parking spots need more.
- Skipping fabric on clay. The stone disappears into the mud.
- No crown. Water ponds, the base softens, potholes follow.
- Using #57 as the driving base. It never locks up. Crusher run is the base; #57 is for drainage.
Get crusher run for your driveway
We make RCA crusher run (1 inch minus with fines) and RCA #57 at our Maryville yard from clean recycled concrete. Pick up in your own truck or trailer, or schedule delivery straight to your driveway. Not sure on depth for your site? Call us and describe the soil and what will drive on it.
- Address: 245 Brookdale Rd, Maryville TN 37801
- Hours: Mon-Fri 7 AM to 5 PM, Sat 8 AM to noon
- Phone: (865) 999-0857, call for current pricing
Frequently Asked Questions
How thick should crusher run be for a driveway?
Four inches compacted is the minimum for cars on firm soil. Go to 6 inches for pickups and regular truck traffic, and 8 inches or more for RVs, delivery trucks, or dump trucks. Measure depth after compaction, not when the stone is loose.
How many inches of crusher run do I need over clay?
Add about 2 inches to the depth you would use on firm soil, and lay geotextile fabric on the clay first. A car driveway on red clay that would get 4 inches on firm ground should get 6 inches over fabric.
Can I put 6 inches of crusher run down in one layer?
Not if you want it to last. Spread crusher run in lifts of about 3 to 4 inches loose, dampen it, and compact each lift before adding the next. One thick dump leaves a soft bottom that ruts.
How many tons of crusher run for a 100 foot driveway?
For a 12 foot wide driveway, about 21 tons at 4 inches, 31 tons at 6 inches, and 41.5 tons at 8 inches, using RCA crusher run at 1.4 tons per cubic yard. Add about 10 percent for waste and uneven ground.
How much does crusher run settle when compacted?
Plan on losing roughly 15 to 25 percent of loose thickness. A 5 inch loose layer usually finishes close to 4 inches once it is wetted and compacted.
Should I put crusher run over an existing gravel driveway?
Yes, if the old base is firm. Regrade the ruts, compact the old surface, and add 2 to 3 inches of crusher run on top. If the old driveway pumps mud or has deep soft spots, dig those out first.
Related Guides
Ready to get started?
Serving Blount County, Knox County, and the greater East Tennessee region. Mon-Fri 7am-5pm, Saturday 8am-12pm.